|
|
|
| Comparative analysis of calibration results of AG2.0 evaporation sensors obtained through different water level measurement methods |
| Qu Bo, Wei Wei, Tang Feng |
| Chongqing Meteorological Information and Technology Support Center,Chongqing 401147 |
|
|
|
|
Abstract The meteorological evaporation sensor uses the principle of ultrasonic distance measurement to measure the height of the water level in the evaporation cylinder.During evaporation calibration,the collector can directly read the water value and measure its output current,and obtain the water level value through the water level current conversion coefficient.The water level current conversion coefficient can be divided into ideal state,full range,and calibration section according to the measurement principle and actual measurement reuirements.By comparing the calibration results of four AG2.0 evaporation sensors under different water level value acquisition methods,it was found that the measurement error of the water level values directly read by the collector and obtained from the water level current conversion coefficient of the calibration section was significantly better than other methods.Therefore,it is recommended to use a collector to directly read during on-site calibration,and to use calibration segment current conversion in laboratory calibration to improve measurement accuracy and further reduce measurement errors.
|
|
Received: 09 October 2024
|
|
|
|
|
|
| Cite this article: |
|
Qu Bo,Wei Wei,Tang Feng. Comparative analysis of calibration results of AG2.0 evaporation sensors obtained through different water level measurement methods[J]. Meteorological Hydrological and Marine Instrument, 2026, 43(1): 30-34.
|
|
|
|
| URL: |
| http://www.qxswhy.com/EN/ OR http://www.qxswhy.com/EN/Y2026/V43/I1/30 |
| [1] |
郑亮,黄小静,刘宗庆,等.新型蒸发校准误差修正[J].气象科技,2018,46(4):665-669.
|
| [2] |
王毛翠,王敏,魏根宝.AG2.0型超声波蒸发传感器应用及检定方法研究[J].气象水文海洋仪器,2019,36(3):88-92.
|
| [3] |
王旭,孙文博,沈天舒,等.AG2型超声蒸发传感器现场校准方法研究[J].气象水文海洋仪器,2021,38(4):66-67,70.
|
|
|
|
2026, Vol. 43 
